Products

The TI series is a thin-type independent chuck that can be used with chuck sizes from 12“ to 39” (φ300 to φ1000). It can be used with a variety of machines, such as angle plates (equerre) and machining center tables, as well as 5-axis machining center tables.
・Cast iron body
・Chuck size: 12“ to 39” (φ300 to φ1000)
・The cover on the top makes it difficult for chips to enter the inside.
・Lightweight and thin design has minimal impact on the maximum loading capacity and height of the machine.

The FBK/FBJ series are boring mill jaws that can accommodate chuck sizes from 32“ to 80” (ø800 to ø2000). The cast iron body makes them suitable for general cutting.
・Cast iron body
・Chuck sizes 32“ to 80” (φ800 to φ2000)
・Boring mill jaws are available in hard solid jaw and two-piece types.
・The top surface of the chuck is T-slot or tapped.

【Series details】
FBK-1P: T-slot specification, hard solid jaw
FBK-2P: T-slot specification, 2-piece hard solid jaw
FBJ-1P: Tapped hole specification, hard solid jaw
FBJ-2P: Tapped hole specification, 2-piece hard solid jaw

3/4/6 Jaws scroll chuck low profile light weight type TM series is a lightweight, thin chuck with a chuck size of 12“ to 39” (φ300 to φ1000). It can be attached to angle plates (equerre), machining center tables, and 5-axis machining center tables.
・Cast iron body
・Chuck size 12“ to 39” (ø300 to ø1000)
・Cover on the upper surface of chuck to prevent chips from entering.
・Lightweight, low-profile design has minimal impact on the maximum load capacity and height of the machine.
・Can be attached to angle plates (equerre), machining center tables, and 5-axis machining center rotary tables.